Floor Board & Brace Repairs.

Drivers side floor board area looking forward.

Drivers side floor boards with new metal positioned.

Drivers side floor board area again with floorboard cut out exposing rusted body brace

and new replacement brace also shown.  The next photo is of these two braces displayed

upside down on the shop floor.

 New drivers side front brace with inner bracing positioned with new metal kick

panel repair.

Close Up of drivers side kick panel new metal positioned.

Left front seat base being removed from rusted floor board area.

Drivers side seat base with new metal.

Same floor board area below left front seat base with new 18 gage metal being

fitted for welding.

New center body brace upside down and on the floor This brace goes below the front

seat - the next photo is of this brace in place.

This is the new Drivers side center brace positioned with new inner rocker panel

metal.

This is one of the larger pieces of the factory asphalt type floor insulation that was

destroyed in getting to the floorboards.  It will be replaced with some "updated"

sound deadening material.

The floorboards just inside the left rear door.  The next photo shows this

area cut out and the replacement metal laid to the side.

The same piece and replacement metal upside down on floor.

Left rear floor new metal repair in place.

Inside left rear door opening and left rear wheel housing.

New metal repair with nut inserts, in place.

New and old body braces in front of left rear wheel.  Next photo is this brace

displayed on floor.

Left rear wheel well housing area where rear seat bracket bolts in.  This area will be

repaired with new metal and then covered with new vinyl as it was from the factory.

The old piece and the new pieces, still needing spot welded together and the

seat base mounting holes drilled.  These pieces are floor displayed in next photo.

Repair in place.

This is the front corner of the rear side glass.  Most of this was covered by the

glass rubber moulding.  The right side has rust also but a smaller area.

This is a new brace for the rear corner of the body, just in front of the rear bumper.

The next photo shows this piece and the old one in place.  The right side is just as rusty

and is also being replaced.

Right side floor boards have smaller areas of rust but will require all the underbody

braces to be replaced as shown for the left side.  This is the passengers side front area.

All of this rust has been cut out and is getting new 18 gage metal.

Passenger floor board rusted mail removed.

Passengers Floor Board New Under Body Brace In Place.

 Passengers Side New Inner Rocker Panel Metal In Place.

 Passengers Floorboard New Metal In Place.

Right rear door opening area. This gets new metal.

Rusted Metal Removed.

Right Rear wheel well housing.  This gets new metal.

 Rusted Metal Removed.

Repair in place for welding.